Installation

SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR: INSTALLATION

1. INSTALL REAR AIRBAG SENSOR

(a) Check that the ignition switch is off.

(b) Check that the battery negative (-) cable is disconnected.

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

(c) Install the rear airbag sensor with the bolt and pin.





Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

NOTICE:
* If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
* When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
* Make sure that the pin is securely inserted into the body hole.
* Tighten the bolt while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.
(d) Check that there are no loose parts after installing the rear airbag sensor.

(e) Connect the connector to the rear airbag sensor.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) Installation

3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) Installation

4. CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY Installation

5. INSTALL FRONT DECK SIDE TRIM COVER Installation

6. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side) Installation

7. INSTALL NO. 2 DECK SIDE TRIM HOOK (for LH Side) Installation

8. INSTALL ROPE HOOK ASSEMBLY Installation

9. INSTALL REAR DECK TRIM COVER (for LH Side without Remote Folding Function) Installation

10. INSTALL RECLINING REMOTE CONTROL BEZEL (for LH Side with Remote Folding Function) Installation

11. INSTALL REAR POWER OUTLET SOCKET COVER (for LH Side) Installation

12. INSTALL REAR POWER POINT SOCKET ASSEMBLY (for LH Side) Installation

13. INSTALL REAR COMBINATION LIGHT SERVICE COVER RH (for RH Side) Installation

14. INSTALL REAR COMBINATION LIGHT SERVICE COVER LH (for LH Side) Installation

15. INSTALL SIDE TRIM COVER RH (for RH Side without Rear Automatic Air Conditioning System) Installation

16. INSTALL REAR ROOM TEMPERATURE SENSOR (for RH Side with Rear Automatic Air Conditioning System) Installation

17. INSTALL SIDE TRIM COVER LH (for LH Side without Rear Seat Entertainment System) Installation

18. INSTALL POWER OUTLET SOCKET BEZEL (for LH Side with Rear Seat Entertainment System) Installation

19. INSTALL DECK SIDE TRIM Installation

20. INSTALL DECK SIDE TRIM COVER Installation

21. INSTALL REAR SEAT SIDE GARNISH CAP (for RH Side without Rear Air Conditioning System) Installation

22. INSTALL REAR SEAT SIDE GARNISH CAP (for RH Side with Rear Air Conditioning System) Installation

23. INSTALL REAR FLOOR FINISH PLATE Installation

24. INSTALL REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat) Installation

25. CONNECT REAR SEAT LAP TYPE BELT ASSEMBLY LH (w/ Rear No. 2 Seat) Installation

26. CONNECT REAR SEAT LAP TYPE BELT ASSEMBLY RH (w/ Rear No. 2 Seat) Installation

27. INSTALL REAR NO. 2 SEAT INNER BELT ASSEMBLY (w/ Rear No. 2 Seat) Installation

28. INSTALL NO. 1 DECK BOARD (w/o Rear No. 2 Seat) Installation

29. INSTALL NO. 1 DECK BOARD (w/ Rear No. 2 Seat) Installation

30. INSTALL REAR DECK FLOOR BOX (w/o Rear No. 2 Seat) Installation

31. INSTALL DECK FLOOR BOARD ASSEMBLY (w/o Rear No. 2 Seat) Installation

32. INSTALL DECK FLOOR BOARD ASSEMBLY (w/ Rear No. 2 Seat) Installation

33. INSTALL REAR MAT Installation

34. INSTALL DECK SIDE TRIM BOX RH Installation

35. INSTALL JACK CARRIER ASSEMBLY Installation

36. INSTALL JACK ASSEMBLY Installation

37. INSTALL JACK CARRIER CUSHION Installation

38. INSTALL JACK CARRIER SUPPORT

39. INSTALL REAR SEAT SIDE COVER RH (w/ Rear No. 2 Seat) Installation

40. INSTALL DECK SIDE TRIM BOX LH Installation

41. INSTALL REAR SEAT SIDE COVER LH (w/ Rear No. 2 Seat) Installation

42. INSTALL REAR NO. 1 FLOOR BOARD (w/o Rear No. 2 Seat) Installation

43. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) Installation

44. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY Installation

45. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY Installation

46. INSTALL DECK BOARD ASSEMBLY Installation

47. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP Installation

48. INSTALL REAR DOOR SCUFF PLATE Installation

49. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization

50. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.