Installation

SUPPLEMENTAL RESTRAINT SYSTEM: SIDE AIRBAG SENSOR: INSTALLATION

1. INSTALL SIDE AIRBAG SENSOR

(a) Check that the ignition switch is off.

(b) Check that the battery negative (-) cable is disconnected.

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

(c) Install the side airbag sensor with the bolt and pin.





Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

NOTICE:
* If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
* When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
* Make sure that the pin is securely inserted into the body hole.
* Tighten the bolt while holding the side airbag sensor because the side airbag sensor pin (stopper) is easily damaged.
(d) Check that there are no loose parts after installing the side airbag sensor.

(e) Connect the connector to the side airbag sensor.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL LOWER CENTER PILLAR GARNISH Installation

3. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP Installation

4. INSTALL REAR DOOR SCUFF PLATE Installation

5. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP Installation

6. INSTALL FRONT DOOR SCUFF PLATE Installation

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization

8. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.