Installation

AXLE: REAR AXLE HUB (for 2WD): INSTALLATION

1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY

(a) Temporarily install the rear axle carrier sub-assembly with the 2 bolts and the 2 nuts.

(b) Install the rear axle carrier sub-assembly with the 2 bolts and the 2 nuts.

Torque : 290 Nm (2956 kgf-cm, 213 ft-lbf)

2. TEMPORARILY INSTALL REAR STRUT ROD ASSEMBLY Installation

3. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

(a) Install the parking brake assembly and the rear axle hub and bearing assembly with the 4 bolts.

Torque : 75 Nm (764 kgf-cm, 55 ft-lbf)

NOTICE:
Do not twist the No. 3 parking brake cable assembly when installing it.

4. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub

5. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub

6. INSTALL REAR SPEED SENSOR WIRE Installation

7. INSTALL REAR DISC Disassembly

8. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Replacement

9. INSTALL REAR FLEXIBLE HOSE Installation

10. STABILIZE SUSPENSION Installation

11. FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY

(a) Fully tighten the bolt.

Torque : 112 Nm (1141 kgf-cm, 82 ft-lbf)

NOTICE:
* Since a stopper nut is used, fully tighten the bolt.
* The final torque must be applied under standard vehicle height conditions.
13. FULLY TIGHTEN REAR STRUT ROD ASSEMBLY Installation

14. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY Installation

15. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization

17. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

HINT
Service and Repair

18. CHECK FOR SPEED SENSOR SIGNAL

HINT
Test Mode Procedure