Replacement

3MZ-FE LUBRICATION: OIL AND OIL FILTER: REPLACEMENT

CAUTION:
* Prolonged and repeated contact with engine oil will cause removal of natural oils from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
* Precautions should be taken when replacing engine oil to minimize the risk of your skin making contact with used engine oil. Wear protective clothing and gloves. Wash your skin thoroughly with soap and water, or use a waterless hand cleaner to remove any used engine oil. Do not use gasoline, thinners or solvents.
* For environmental protection, used oil and used oil filters must be disposed of at designated disposal sites.
1. REMOVE COOL AIR INTAKE DUCT SEAL Removal

2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal

3. DRAIN ENGINE OIL

(a) Remove the oil filler cap.

(b) Remove the oil drain plug and drain the oil into a container.

(c) Clean and install the oil pan drain plug with a new gasket.

Torque : 45 Nm (459 kgf-cm, 33 ft-lbf)

4. REMOVE OIL FILTER

(a) Using SST, remove the oil filter.

SST : 09228-07501

5. INSTALL OIL FILTER

(a) Check and clean the oil filter installation surface.

(b) Apply clean engine oil to the gasket of a new oil filter.

(c) Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.

(d) Using SST, tighten the oil filter.

SST : 09228-07501

(e) Depending on the work space available, choose from the following:

(1) If enough space is available, use a torque wrench to tighten the oil filter.

Torque : 18 Nm (180 kgf-cm, 13 ft-lbf)

(2) If enough space is not available to use a torque wrench, tighten the oil filter a 3/4 turn by hand or use a common wrench.

6. ADD ENGINE OIL

(a) Add new oil.

Engine oil:





Specification:





7. INSPECT FOR OIL LEAK

8. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation

9. INSTALL COOL AIR INTAKE DUCT SEAL Installation