Removal

P310 HYBRID BATTERY CONTROL: SERVICE PLUG GRIP: REMOVAL

1. PRECAUTION

Service Precautions

2. DTC OUTPUT

(a) Check for DTCs.

NOTICE:
Check for DTCs and confirm that P0AA6 (High voltage insulation is unusual) is not output before doing removal or installation inside the battery. If the DTC is output, perform troubleshooting first.

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. REMOVE SERVICE PLUG GRIP

CAUTION:
* Remove the service plug to interrupt a high voltage circuit at the time of the check.
* Keep the removed service plug in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.
* All the high voltage wiring connectors are colored in orange.
(a) Remove the 5 clips and door scuff plate LH.





(b) Remove the 2 clips and reclining hinge cover.





(c) Wear insulated glove and remove the service plug grip, after sliding up the lever of the service plug grip.





CAUTION:
* Keep the removed service plug in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.
* After removing the service plug grip, do not touch the high voltage connectors and terminals for 5 minutes.

NOTICE:
After removing the service plug grip, do not operate the power switch as it may damage the hybrid vehicle control ECU.