Diagnosis Display Detailed Description

NAVIGATION: NAVIGATION SYSTEM: DIAGNOSIS DISPLAY DETAILED DESCRIPTION

HINT
* This section contains a detailed description of displays in diagnostic mode.
* Illustrations may differ from the actual vehicle screen depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle screen.
1. SYSTEM CHECK

(a) System Check Mode Screen





(1) Device Names and Hardware Address/*1

HINT
* Registered device names are displayed.
* If a device name is unknown to the system, its physical address is shown instead.






(2) Check Result/*2

HINT
Result codes for all devices are displayed.





(3) Code Clear/*3

* Present DTCs are cleared.

* Press the "Code CLR" switch for 3 seconds.

(4) Memory Clear/*4

* Present and past DTCs and registered connected device names are cleared.

* Press the "Memory CLR" switch for 3 seconds.

(b) Diagnosis MENU Screen





HINT
Each item is grayed out or not displayed based on the device settings.

(c) Unit Check Mode Screen









(d) LAN Monitor (Original) Screen





(1) Check Result/*1

HINT
Check results of all the devices are displayed.





(e) LAN Monitor (Individual) Screen









2. DISPLAY CHECK

(a) Vehicle Signal Check Mode Screen









HINT
* Only items sending vehicle signals will be displayed.
* This screen is updated once per second when input signals to the vehicle are changed.
3. NAVIGATION CHECK

(a) Navigation Check Screen





HINT
Each item is grayed out or not displayed based on the device settings.

(b) GPS Information Screen





(1) Satellite information/*1

Information from a maximum of 12 satellites is displayed on the screen. This information includes the target GPS satellite number, elevation angle, direction, and signal level.

(2) Receiving condition/*2





















(c) Vehicle Sensors Screen













HINT
Signals are updated once per second only when vehicle sensor signals are changed.

(d) Microphone & Voice Recognition Check Screen









HINT
* The microphone input function is on at all times when this screen is displayed.
* While recording or playing, the switches other than the stop switch cannot be pushed.
* When no voice is recorded, the play switch cannot be pushed.
* Recording will stop after 5 seconds or by pushing the stop switch.
(e) DVD Player Information Screen













HINT
This is a DVD player check function in the navigation receiver assembly (built-in navigation ECU).