Steering System

STEERING COLUMN: STEERING SYSTEM: PRECAUTION

1. IGNITION SWITCH EXPRESSIONS

HINT
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.





2. HANDLING PRECAUTIONS FOR STEERING SYSTEM

(a) Care must be taken when replacing parts. Incorrect replacement may affect the performance of the steering system and result in driving hazards.

3. HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM

(a) The vehicle is equipped with SRS (Supplemental Restraint System). Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing. This may cause a serious accident. Before servicing (including inspection, replacement, removal, and installation of parts), be sure to read the precautionary notices for the Supplemental Restraint System Service Precautions.

4. HANDLING PRECAUTIONS FOR STEERING COLUMN

(a) When handling the steering column assembly:

(1) Avoid any impact to the steering column assembly, especially to the motor or the torque sensor. Replace the steering column assembly with a new one if it is dropped or subjected to any severe impacts.

(2) Do not pull the wire harness when moving the steering column assembly.

(3) Do not release the tilt lever when the steering column assembly is not installed on the vehicle.

(b) When disconnecting or reconnecting the connectors:

(1) When disconnecting the connectors related to the electronic motor power steering system, turn the ignition switch on (IG) (the engine is stopped), center the steering wheel, turn the ignition switch off, and then disconnect the connectors.

(2) When reconnecting the connectors related to the electronic motor power steering system, make sure that the ignition switch is turned off, center the steering wheel and then turn the ignition switch on (IG) (the engine is stopped).

NOTICE:
Do not turn the ignition switch on (IG) without the steering wheel being centered.