Removal

HEATING / AIR CONDITIONING: AIR CONDITIONING UNIT: REMOVAL

1. PRECAUTION

Lower Instrument Panel

2. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Service Precautions.

4. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM Service and Repair

5. DISCONNECT SUCTION PIPE SUB-ASSEMBLY

(a) Remove the bolt and slide the hook connector.

(b) Disconnect the suction pipe sub-assembly.

(c) Remove the O-ring from the suction hose sub-assembly.

NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

6. DISCONNECT LIQUID PIPE SUB-ASSEMBLY

(a) Disconnect the liquid pipe sub-assembly.

(b) Remove the O-ring from the liquid pipe sub-assembly.

NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

7. DISCONNECT HEATER WATER HOSE OUTLET

(a) Using pliers, grip the claws of the clip and slide the clip to disconnect the heater outlet water hose.

NOTICE:
* Do not apply excessive force to the heater outlet water hose.
* Prepare a drain pan or cloth in case the coolant leaks.
8. DISCONNECT HEATER WATER HOSE INLET

HINT
Disconnection procedure for the heater inlet water hose is the same as that for the heater outlet water hose.

9. REMOVE LOWER NO. 3 STEERING WHEEL COVER Removal

10. REMOVE LOWER NO. 2 STEERING WHEEL COVER Removal

11. REMOVE STEERING PAD Removal

12. REMOVE STEERING WHEEL ASSEMBLY Removal

13. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Removal

14. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Removal

15. REMOVE METER HOOD SUB-ASSEMBLY Removal

16. REMOVE COMBINATION METER ASSEMBLY Removal

17. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH Removal

18. REMOVE FRONT PILLAR GARNISH LH (w/o Curtain Shield Airbag) Removal

19. REMOVE FRONT PILLAR GARNISH LH (w/ Curtain Shield Airbag) Removal

20. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH Removal

21. REMOVE FRONT PILLAR GARNISH RH (w/o Curtain Shield Airbag) Removal

22. REMOVE FRONT PILLAR GARNISH RH (w/ Curtain Shield Airbag) Removal

23. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Removal

24. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Removal

25. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle) Removal

26. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Manual Transaxle) Removal

27. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Automatic Transaxle) Removal

28. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal

29. REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY Removal

30. DISCONNECT INSTRUMENT PANEL WIRE ASSEMBLY Removal

31. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY Removal

32. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System) Removal

33. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System) Removal

34. REMOVE NAVIGATION ANTENNA CORD SUB-ASSEMBLY (w/ Navigation System) Removal

35. REMOVE AIR CONDITIONING PANEL ASSEMBLY Removal

36. REMOVE FRONT UPPER CONSOLE BOX Removal

37. REMOVE NO. 2 SWITCH HOLE BASE Removal

38. REMOVE CONSOLE BOX CARPET

39. REMOVE FRONT CONSOLE BOX ASSEMBLY (for 2WD) Removal

40. REMOVE FRONT CONSOLE BOX ASSEMBLY (for 4WD) Removal

41. REMOVE FRONT NO. 1 CONSOLE BOX INSERT Removal

42. REMOVE FRONT NO. 2 CONSOLE BOX INSERT Removal

43. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for Manual Transaxle) Removal

44. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for Automatic Transaxle) Removal

45. REMOVE NO. 1 SWITCH HOLE BASE Removal

46. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Removal

47. REMOVE FRONT DOOR SCUFF PLATE LH Removal

48. REMOVE COWL SIDE TRIM BOARD LH Removal

49. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Instrument Panel Under Cover) Removal

50. REMOVE FRONT DOOR SCUFF PLATE RH Removal

51. REMOVE COWL SIDE TRIM BOARD RH Removal

52. DISCONNECT SHIFT LEVER ASSEMBLY (for Manual Transaxle) Removal

53. DISCONNECT SHIFT LEVER ASSEMBLY (for Automatic Transaxle) Removal

54. REMOVE LOWER STEERING COLUMN COVER Removal

55. REMOVE UPPER STEERING COLUMN COVER Removal

56. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY Removal

57. REMOVE RADIO WIRE SUB-ASSEMBLY Removal

58. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY Removal

59. REMOVE COLUMN HOLE COVER SILENCER SHEET Removal

60. SEPARATE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (for 2WD) Removal

61. SEPARATE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (for 4WD) Removal

62. REMOVE INSTRUMENT PANEL SUB REINFORCEMENT Removal

63. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY Removal

64. REMOVE TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System) Removal

65. REMOVE STOP LIGHT SWITCH ASSEMBLY Removal

66. REMOVE STEERING POST ASSEMBLY Removal

67. REMOVE POWER STEERING ECU ASSEMBLY Removal

68. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY Removal

69. REMOVE REAR NO. 3 AIR DUCT (w/ Rear Air Duct)

(a) Remove the clip.

(b) Turn back the floor carpet.

(c) Disengage the 2 claws and remove the rear No. 3 air duct.

70. REMOVE REAR NO. 2 AIR DUCT (w/ Rear Air Duct)

(a) Remove the clip.

(b) Turn back the floor carpet.

(c) Disengage the 2 claws and remove the rear No. 2 air duct.

71. REMOVE REAR NO. 1 AIR DUCT (w/ Rear Air Duct)

(a) Disengage the 4 claws and remove the rear No. 1 air duct.

72. REMOVE CENTER INSTRUMENT PANEL REGISTER CONNECTOR ASSEMBLY

(a) Disengage the 6 claws and remove the center instrument panel register connector assembly.

73. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY

(a) Remove the 2 nuts and the No. 1 air duct sub-assembly.

74. REMOVE CENTER INSTRUMENT PANEL TO COWL BRACE

(a) Remove the 2 bolts and the center instrument panel to cowl brace.

75. REMOVE THEFT WARNING ECU ASSEMBLY Removal

76. REMOVE INSTRUMENT PANEL BRACE SUB-ASSEMBLY

(a) Remove the 2 bolts.

(b) Disconnect the connector.

(c) Disengage each clamp.

(d) Remove the 2 screws.

(e) Remove the 2 bolts, the 2 nuts, and the instrument panel brace sub-assembly.

77. REMOVE HEATER COVER (w/ Cover)

(a) Disengage the 4 claws and remove the heater cover.

78. REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY

(a) Disengage each clamp and the wire harness.

(b) Disconnect each connector.

(c) Disengage each clamp.

(d) Remove the 9 bolts, and disengage the wire harness and junction block.

(e) Remove the 7 bolts.

(f) Remove the 3 bolts and the instrument panel reinforcement assembly.

79. REMOVE AIR CONDITIONING UNIT

(a) Disengage the drain cooler hose.

(b) Remove the bolt, the nut, and the air conditioning unit.

NOTICE:
* Be sure to support the air conditioning unit assembly when removing it because failure to do so may cause the bracket of the air conditioning unit assembly to break.
* When disassembling the air conditioning unit, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.
80. REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY

(a) Disengage the 2 claws and remove the No. 3 air duct sub-assembly.

81. REMOVE BLOWER ASSEMBLY (w/o PTC Heater)

(a) Remove the 3 screws and the blower assembly.

82. REMOVE BLOWER ASSEMBLY (w/ PTC Heater)

(a) Disengage each clamp.

(b) Remove the screw and disengage the quick heater connector.