Installation

2GR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION

1. INSTALL FAN & GENERATOR V BELT





(a) Rotate the tensioner pulley counterclockwise, and then install the V-ribbed belt.

(b) If it is difficult to install the V-ribbed belt, perform the following procedure.





(1) Put the V-ribbed belt on everything except the tensioner pulley as shown in the illustration.

(2) While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.

NOTICE:
* Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
* Check that the V-ribbed belt is properly set to each pulley.
2. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH





(a) Install the reinforcement with the 4 bolts.

Torque : 95 Nm (969 kgf-cm, 70 ft-lbf)

3. INSTALL ENGINE UNDER COVER RH

(a) Install the engine under cover with the 2 clips.

4. INSTALL NO. 1 ENGINE UNDER COVER Installation

5. CONNECT RADIATOR RESERVOIR TANK ASSEMBLY

(a) Connect the reservoir tank with the 2 bolts.





Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)