Installation

DOOR LOCK: DOOR CONTROL RECEIVER: INSTALLATION

1. INSTALL DOOR CONTROL RECEIVER





(a) Install the receiver with the bolt.

(b) Connect the receiver connector.

2. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY RH (w/o Rear No. 2 Seat)





(a) Attach the 7 clips to install the garnish.

3. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY RH (w/ Rear No. 2 Seat)





(a) Attach the 7 slips to install the garnish.

(b) Connect the rear No. 2 seat belt's shoulder anchor.

(1) Connect the shoulder anchor with the bolt.

Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)





(2) Attach the claws to close the seat belt anchor cover.

4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (w/o Rear No. Seat) Removal

5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (w/ Rear No. 2 Seat) Removal

6. INSTALL TETHER ANCHOR BRACKET SUB-ASSEMBLY (w/o Rear No. 2 Seat)





(a) Install the tether anchor bracket with the bolt.

7. INSTALL RECLINING REMOTE CONTROL LEVER BEZEL RH (w/o Rear No. 2 Seat) Installation

8. INSTALL REAR DECK TRIM COVER RH (w/ Rear No. 2 Seat)

(a) Attach the 4 claws to install the trim cover.

(b) Install the belt.

9. INSTALL REAR FLOOR FINISH PLATE Removal

10. INSTALL REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE Removal

11. INSTALL REAR FLOOR NO. 3 BOARD

12. INSTALL REAR FLOOR NO. 2 BOARD

13. INSTALL REAR NO. 2 SEAT ASSEMBLY LH (w/ Rear No. 2 Seat) Installation

14. INSTALL REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)

HINT
Use the same procedures described for the LH side.

15. INSTALL NO. 2 SEAT LEG COVER LH (w/ Rear No. 2 Seat) Installation

16. INSTALL NO. 2 SEAT LEG COVER RH (w/ Rear No. 2 Seat)

HINT
Use the same procedures described for the LH side.

17. INSTALL NO. 2 SEAT HINGE COVER LH (w/ Rear No. 2 Seat) Installation

18. INSTALL NO. 2 SEAT HINGE COVER RH (w/ Rear No. 2 Seat)

HINT
Use the same procedures described for the LH side.

19. INSTALL DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)

20. INSTALL REAR FLOOR NO. 1 BOARD (w/o Rear No. 2 Seat)

21. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH

22. INSTALL REAR DOOR SCUFF PLATE RH





(a) Attach the 9 claws and 2 clips to install the scuff plate.