Operation CHARM: Car repair manuals for everyone.

Installation





AXLE: FRONT AXLE HUB: INSTALLATION

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are the LH side.
1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH





(a) Install the dust cover to the steering knuckle.

(b) Install the axle hub with the 4 bolts.

Torque : 96 Nm (979 kgf-cm, 71 ft-lbf)

NOTICE:
Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.

2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY LH Installation

3. INSTALL STEERING KNUCKLE WITH AXLE HUB

(a) Align the shaft splines and drive in the drive shaft.

(b) Install the steering knuckle with axle hub with the 2 bolts and 2 nuts.

Torque : 240 Nm (2447 kgf-cm, 177 ft-lbf)

NOTICE:
Do not tighten the bolts.

4. CONNECT FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY LH

(a) Connect the lower arm to the ball joint with the bolt and 2 nuts.

Torque : 92 Nm (938 kgf-cm, 68 ft-lbf)

5. CONNECT TIE ROD END SUB-ASSEMBLY LH Installation

6. INSTALL FRONT SPEED SENSOR LH Installation

7. CHECK FRONT AXLE HUB BEARING

(a) Check the axle hub bearing Front Axle Hub.

8. INSTALL FRONT DISC Reassembly

9. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH Installation

10. INSTALL FRONT AXLE SHAFT LH NUT

(a) Install a new hub nut.

Torque : 216 Nm (2203 kgf-cm, 159 ft-lbf for 26 for 2AR-FE)

Torque : 292 Nm (2978 kgf-cm, 215 ft-lbf for 30 for 2GR-FE)





(b) Using a chisel and hammer, stake the hub nut.

11. ADD AUTOMATIC TRANSAXLE FLUID

(a) Add the automatic transaxle for U140F Installation.

(b) Add the automatic transaxle for U241E .

(c) Add the automatic transaxle for U151E .

(d) Add the automatic transaxle for U151F .

12. CHECK FOR AUTOMATIC TRANSAXLE FLUID LEAKAGE

13. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

14. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

(a) Inspect and adjust the front wheel alignment Service and Repair.

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

16. CHECK SPEED SENSOR SIGNAL

(a) Check the speed sensor signal Diagnosis System.