Parking Brake Switch Circuit

NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM (w/ USB Audio System): Parking Brake Switch Circuit
- Parking Brake Switch Circuit

DESCRIPTION

This circuit is from the parking brake switch to the navigation receiver assembly.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK PARKING BRAKE SWITCH ASSEMBLY (DISPLAY CHECK MODE)

(a) Enter the "Display Check" mode and select "Vehicle Signal Check" Operation Check.





(b) Check that the display changes between ON and OFF according to the parking brake operation.

OK:





HINT
This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.

NG -- CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - PARKING BRAKE SWITCH)

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Problem Symptoms Table

2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - PARKING BRAKE SWITCH)

(a) Disconnect the I6 navigation receiver assembly connector.





(b) Disconnect the A5 parking brake switch assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Problem Symptoms Table

3. INSPECT PARKING BRAKE SWITCH ASSEMBLY

(a) Remove the parking brake switch assembly connector Testing and Inspection.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPLACE PARKING BRAKE SWITCH ASSEMBLY Testing and Inspection

OK -- REPAIR OR REPLACE HARNESS OR CONNECTOR