Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE FRONT DOOR SCUFF PLATE LH Removal

3. REMOVE COWL SIDE TRIM BOARD LH Removal

4. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH Removal

5. REMOVE FRONT PILLAR GARNISH LH Removal

6. REMOVE INSTRUMENT SIDE PANEL LH Removal

7. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Removal

8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH Removal

9. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

10. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

11. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

12. REMOVE REAR CONSOLE BOX POCKET Removal

13. REMOVE CONSOLE BOX CARPET Removal

14. REMOVE REAR CONSOLE BOX ASSEMBLY Removal

15. REMOVE FRONT CONSOLE BOX Removal

16. REMOVE AIRBAG SENSOR ASSEMBLY





CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

(a) Pull the lever down and detach the connector holder.

(b) Remove the 3 bolts and remove the airbag sensor.