Installation

EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION

1. INSTALL FRONT BUMPER COVER

(a) Connect the connectors.

HINT
This procedure is only necessary for vehicles equipped with fog lights or the intuitive parking assist system.

(b) Attach the 4 claws to install the front bumper cover.

(d) Install the 7 screws.

for screws labeled A - Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

(e) Install the 2 pin hold clips so that their grooves are vertical.

HINT
Use the same procedure for the RH side and LH side.

(f) Install the clip.

HINT
Use the same procedure for the RH side and LH side.

(g) Install the screw.

HINT
Use the same procedure for the RH side and LH side.

2. INSTALL FRONT END PANEL LH (w/o Headlight Cleaner System) Installation

3. INSTALL FRONT END PANEL RH (w/o Headlight Cleaner System)

HINT
Use the same procedure described for the LH side.

4. INSTALL FRONT END PANEL LH (w/ Headlight Cleaner System) Installation

5. INSTALL FRONT END PANEL RH (w/ Headlight Cleaner System)

HINT
Use the same procedure described for the LH side.

6. PREPARE VEHICLE FOR HEADLIGHT AIMING ADJUSTMENT Adjustments

7. PREPARE FOR HEADLIGHT AIMING (for Using a Tester) Adjustments

8. PREPARE FOR HEADLIGHT AIMING (for Using a Screen) Adjustments

9. INSPECT HEADLIGHT AIMING Adjustments

10. ADJUST HEADLIGHT AIMING Adjustments

11. PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT (w/ Fog Light) Adjustments

12. PREPARE FOR FOG LIGHT AIMING (w/ Fog Light) Adjustments

13. INSPECT FOG LIGHT AIMING (w/ Fog Light) Adjustments

14. ADJUST FOG LIGHT AIMING (w/ Fog Light) Adjustments