Installation

3UR-FBE FUEL: FUEL PUMP: INSTALLATION

1. INSTALL FUEL SENDER GAUGE ASSEMBLY Installation

2. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY Installation

3. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY

(a) Apply a light coat of gasoline or grease to a new gasket and install it to the fuel tank.





(b) Align the protrusion of the fuel suction with pump and gauge tube assembly with the groove of the fuel tank.

(c) Install the fuel suction with pump and gauge tube assembly into the fuel tank.

NOTICE:
Be careful not to bend the arm of the fuel sender gauge.

(d) Put the retainer on the fuel tank. While holding the fuel suction with pump and gauge tube assembly, tighten the retainer one complete turn by hand.

(e) Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank, as shown in the illustration.





SST : 09808-14020

HINT
Fit the tips of SST onto the ribs of the retainer.

4. INSTALL FUEL PRESSURE SWITCHING VALVE ASSEMBLY Installation

5. INSTALL FUEL TANK ASSEMBLY

(a) Install the fuel tank assembly Installation.