Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: REAR AIRBAG SENSOR: INSTALLATION
1. INSTALL REAR AIRBAG SENSOR RH
(a) Check that the ignition switch is off.
(b) Check that the battery negative (-) terminal is disconnected.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Engage the guide and Install the rear airbag sensor.
(d) Install the bolt.
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
CAUTION:
* If the rear airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
* When installing the rear airbag sensor LH, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
(e) Check that there is no looseness in the installation parts of the rear airbag sensor.
(f) Connect the connector to the rear airbag sensor.
2. INSTALL REAR AIRBAG SENSOR LH
HINT
Use the same procedure as for the RH side.
3. INSTALL REAR SIDE NO. 3 AIR DUCT Installation
4. INSTALL QUARTER TRIM PANEL ASSEMBLY RH (for Standard) Installation
5. INSTALL QUARTER TRIM PANEL ASSEMBLY LH (for Standard) Installation
6. INSTALL QUARTER TRIM PANEL ASSEMBLY RH (for Power Seat) Installation
7. INSTALL QUARTER TRIM PANEL ASSEMBLY LH (for Power Seat) Installation
8. INSTALL REAR FLOOR MAT SUPPORT PLATE Installation
9. INSTALL ROPE HOOK ASSEMBLY Installation
10. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH Installation
11. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH Installation
12. INSTALL REAR DOOR SCUFF PLATE RH Installation
13. INSTALL REAR DOOR SCUFF PLATE LH Installation
14. INSTALL REAR FLOOR STEP NO. 1 COVER Installation
15. INSTALL REAR FLOOR STEP NO. 2 COVER Installation
16. INSTALL REAR SEAT CUSHION HINGE LOWER COVER RH Installation
17. INSTALL REAR SEAT CUSHION HINGE LOWER COVER LH Installation
18. INSTALL REAR NO. 2 SEAT ASSEMBLY RH
(a) for Manual seat:
Install the rear No. 2 seat assembly RH Installation
(b) for Power Seat:
Install the rear No. 2 seat assembly RH Installation
19. INSTALL REAR NO. 2 SEAT ASSEMBLY LH
(a) for Manual seat:
Install the rear No. 2 seat assembly LH Installation
(b) for Power Seat:
Install the rear No. 2 seat assembly LH Installation
20. INSTALL DECK BOARD BRACKET Installation
21. INSTALL DECK BOARD REINFORCEMENT SUB-ASSEMBLY Installation
22. INSTALL NO. 1 DECK BOARD SUB-ASSEMBLY Installation
23. INSTALL ROPE HOOK ASSEMBLY Installation
24. INSTALL LUGGAGE COMPARTMENT TRIM BOX Installation
25. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY Installation
26. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
27. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.