Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR: INSTALLATION

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.

HINT
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY

(a) Confirm that the ignition switch is turned off.

(b) Confirm that the cable is disconnected from the battery negative (-) terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Engage the guide and install the airbag sensor with the bolt.





Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

NOTICE:
* Do not use a side airbag sensor that has been dropped.
* Do not subject the side airbag sensor to any impact or force.
(d) Confirm that there is no looseness by shaking the side airbag sensor.

(e) Connect the airbag connector.

2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY Reassembly

3. INSTALL FRONT ARMREST BASE UPPER PANEL Reassembly

4. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG Reassembly

5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH Reassembly

6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH (for 14 Speakers) Reassembly

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

CAUTION:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

8. INSPECT SRS WARNING LIGHT

(a) Inspect SRS warning light Diagnosis System.