Installation

METER / GAUGE / DISPLAY: COMBINATION METER: INSTALLATION

1. INSTALL COMBINATION METER ASSEMBLY

(a) Connect the connector and engage the clip and install the combination meter assembly.





(b) Install the 4 screws.





2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Installation

3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

4. INSTALL INSTRUMENT SIDE PANEL LH Installation

5. INSTALL COWL SIDE TRIM BOARD LH Installation

6. INSTALL FRONT DOOR SCUFF PLATE LH Installation

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

8. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.