Installation

3UR-FE STARTING: STARTER: INSTALLATION

1. INSTALL STARTER ASSEMBLY

(a) Install the flywheel housing side cover.





(b) Install the starter with the 2 bolts.





Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)

(c) Install the starter wire with the nut.





Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

(d) Connect the starter connector.

2. INSTALL STARTER COVER





(a) Install the starter cover with the 3 bolts.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH Installation

4. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR Installation

5. INSTALL FRONT NO. 3 FLOOR HEAT INSULATOR Installation

6. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

7. INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE

(a) Apply a light coat of engine oil to a new O-ring.

(b) Install the O-ring to the guide.





(c) Install the dipstick guide with the bolt.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(d) Connect the wire harness clamp.

(e) Install the dipstick.

8. INSTALL FRONT FENDER APRON SEAL RH Installation

9. INSPECT FOR EXHAUST GAS LEAK Installation

10. INSTALL NO. 1 ENGINE UNDER COVER Replacement

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.