Indicator Circuit

SEAT: REAR NO. 2 SEAT ASSEMBLY (w/ Power Stowing Function): Indicator Circuit
- Indicator Circuit

DESCRIPTION

This system has two indicator lights. One of the indicator lights is built into the fold seat switch. This indicator light receives power from the fold seat control ECU. It comes on or blinks when the system detects that an object is caught or when the seat operation conditions are not met.

The other indicator light is on the combination meter. This indicator light comes on when the reclining motor or fold seat control ECU is not initialized, any seat legs are released, or when the seatback is outside the reclining operation range.

WIRING DIAGRAM





INSPECTION PROCEDURE

HINT
* When the indicator light on the fold seat switch does not come on, start troubleshooting from step 1.
* When the indicator light on the combination meter does not come on, start troubleshooting from step 6.

PROCEDURE

1. INSPECT FOLD SEAT SWITCH

(a) Remove the fold seat switch.

(b) Disconnect the connector from the fold seat switch.





(c) Connect the positive (+) lead from the battery terminal 3 and negative (-) lead to terminal 5, and check that the indicator light comes on.

OK:

Indicator light comes on.

NG -- REPLACE FOLD SEAT SWITCH
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (FOLD SEAT CONTROL ECU - FOLD SEAT SWITCH)

(a) Disconnect the connector from the fold seat control ECU.





(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

LH side





RH side





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (FOLD SEAT SWITCH - BACK DOOR COURTESY SWITCH)

(a) Disconnect the connector from the back door courtesy switch.





(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

LH side





RH side





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

4. INSPECT BACK DOOR COURTESY SWITCH

(a) Measure the resistance according to the value(s) in the table below.





Standard resistance:





NG -- REPLACE BACK DOOR COURTESY SWITCH
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (BACK DOOR COURTESY SWITCH - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.





Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

6. CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY)

(a) Remove the combination meter.

(b) Disconnect the connector from the combination meter.





(c) Measure the voltage according to the value(s) in the table below.

Standard voltage:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

7. CHECK HARNESS AND CONNECTOR (COMBINATION METER - FOLD SEAT CONTROL ECU)

(a) Disconnect the connector from the fold seat control ECU.





(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

LH side





RH side





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

8. INSPECT COMBINATION METER (3rd SEAT INDICATOR LIGHT)

(a) Connect the positive (+) lead from the battery terminal 32 and negative (-) lead to terminal 3, and check that the indicator light comes on.





OK:

Indicator light comes on.

NG -- REPLACE COMBINATION METER

OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE