Installation

SUPPLEMENTAL RESTRAINT SYSTEM: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.
1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH

(a) Install the curtain shield airbag assembly LH with the 13 bolts in the order shown in the illustration.





Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)

NOTICE:
Do not twist the curtain shield airbag assembly LH when installing it.

(b) Install the clip.

(c) Connect the connector to the curtain shield airbag assembly LH.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL POWER BACK DOOR UNIT ASSEMBLY

3. INSTALL ROOF HEADLINING ASSEMBLY

HINT
Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY" Installation.

4. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY

HINT
Installation

5. INSPECT STEERING WHEEL CENTER POINT

6. INSTALL STEERING PAD

HINT
Installation

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

8. PERFORM INITIALIZATION

(a) Perform initialization.

HINT
Some systems need initialization when disconnecting the cable from the negative battery terminal.

9. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.