Reassembly

AXLE: FRONT AXLE HUB: REASSEMBLY

1. INSTALL FRONT AXLE HUB LH BEARING

(a) Using SST(s) and a press, install a new front axle hub LH bearing to the steering knuckle LH.





SST : 09950-60020

09951-00810

SST : 09950-70010

09951-07100

2. INSTALL DISC BRAKE DUST COVER FRONT LH

(a) Place the disc brake dust cover front LH and using a torx wrench (T30), torque the 4 bolts.

Torque : 8.3 Nm (85 kgf-cm, 74 in-lbf)

HINT
Torx is a registered trademark of Textron Inc.

3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

(a) Using SST(s), and a press, install the front axle hub sub-assembly LH.





SST : 09608-32010

SST : 09950-60020

09951-00810

SST : 09950-70010

09951-07100

4. INSTALL FRONT AXLE HUB LH HOLE SNAP RING

(a) Using snap ring pliers, install a new front axle hub LH hole snap ring.





5. INSTALL FRONT WHEEL BEARING DUST DEFLECTOR NO.1 LH

(a) Using SST(s) and a hammer, install the bearing dust deflector No. 1 LH.





SST : 09316-60011

09316-00011

09316-00031

SST : 09608-32010

HINT
Align the hole for the speed sensor in the bearing dust deflector No. 1 LH with the steering knuckle.

6. INSTALL LOWER BALL JOINT ASSEMBLY FRONT LH

(a) Install the lower ball joint assembly front LH and tighten the nut.

Torque : 123 Nm (1,250 kgf-cm, 91 ft-lbf)

(b) Install a new cotter pin.

NOTICE:
If the holes for the cotter pin are not aligned, tighten the nut up to 60° further.