TS and CG Terminal Circuit

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster): TS and CG Terminal Circuit
- TS and CG Terminal Circuit

DESCRIPTION

In sensor check mode, malfunctions of the speed sensor that cannot be detected when the vehicle is stopped are detected while driving.

Transition to the sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from OFF to the ON position.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. INSPECT DLC3 (TS TERMINAL VOLTAGE)

(a) Turn the ignition switch to the ON position.

(b) Measure the voltage.

Standard:

(c) Turn the ignition switch to OFF.

NG -- CHECK HARNESS AND CONNECTOR (BODY GROUND - DLC3)
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3)

(a) Disconnect the skid control ECU connector.

(b) Measure the resistance.

Standard:

(d) Reconnect the skid control ECU connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE MASTER CYLINDER SOLENOID

3. CHECK HARNESS AND CONNECTOR (BODY GROUND - DLC3)

(a) Measure the resistance.

Standard:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3)

(a) Disconnect the skid control ECU connector.

(b) Measure the resistance.

Standard:

(d) Reconnect the skid control ECU connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE MASTER CYLINDER SOLENOID