Front Stabilizer Bar (for 4WD and Pre-Runner)

SUSPENSION: FRONT STABILIZER BAR (for 4WD and Pre-Runner): INSPECTION

1. INSPECT FRONT STABILIZER LINK ASSEMBLY





(a) Flip the ball joint stud back and forth 5 times, as shown in the illustration, before installing the nut.

(b) Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the 5th turn.

Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf) or less

(c) Check for any cracks and grease leakage on the ball joint dust cover.