Removal

AXLE: FRONT AXLE HUB (for 4WD and Pre-Runner): REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT WHEEL

3. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with painted surfaces.

4. SEPARATE FRONT SPEED SENSOR





(a) Remove the bolt and separate the speed sensor front LH.

(b) Disengage the 2 clamps.

(c) Remove the bolt and separate the speed sensor wire harness from the steering knuckle.

5. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY





(a) Remove the bolt and separate the brake tube bracket from the steering knuckle.

(b) Using a union nut wrench, disconnect the brake tube from the disc brake cylinder.





NOTICE:
Use a container to catch the brake fluid as it drains out.

(c) Remove the 2 bolts and disc brake caliper.





6. REMOVE FRONT DISC

7. REMOVE FRONT AXLE HUB GREASE CAP (for 4WD)





(a) Using a screwdriver and a hammer, remove the front axle hub grease cap.

NOTICE:
Do not damage the axle hub.

8. REMOVE FRONT AXLE HUB NUT (for 4WD)





(a) Remove the cotter pin and lock cap.

(b) Remove the front axle hub nut.

9. SEPARATE FRONT STABILIZER LINK ASSEMBLY





(a) Remove the nut and separate the stabilizer link from the steering knuckle.

HINT
If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.

10. SEPARATE TIE ROD END SUB-ASSEMBLY





(a) Remove the cotter pin and nut.

(b) Using SST, separate the tie rod end from the steering knuckle.

SST : 09628-62011

11. REMOVE FRONT SUSPENSION LOWER ARM





(a) Remove the 2 bolts, and separate the front suspension lower arm from the front axle.

12. SEPARATE FRONT SUSPENSION UPPER ARM





(a) Support the front suspension lower arm with a jack.

(b) Remove the clip and nut.

(c) Using SST, separate the steering knuckle from the front suspension upper arm.

SST : 09628-62011

13. REMOVE FRONT AXLE HUB

(a) for 4WD:

(1) Using a plastic hammer, separate the front axle hub from the front drive shaft.

(b) Remove the front axle hub.