SFR Solenoid Circuit - Vehicle Stability Control System (for Hydraulic Brake Booster)

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster): C0226/21,C0236/22,C0246/23,C0256/24,C1225/25-C1228/28: SFR Solenoid Circuit
C1228/28 - STR Solenoid Circuit

DESCRIPTION

The solenoid goes on when signals are received from the skid control ECU and controls the pressure action on the wheel cylinders thus controlling the braking force.





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. RECONFIRM DTC

HINT
This DTCs are set when a problem is identified in the master cylinder solenoid (skid control ECU).

The solenoid circuit is in the master cylinder solenoid.

Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTCs are output before replacing the master cylinder solenoid.

(a) Clear the DTC Vehicle Stability Control System (for Hydraulic Brake Booster).

(b) Check if the same DTCs are detected.





B -- END

A -- REPLACE MASTER CYLINDER SOLENOID