Foreign Object is Attached on Tip of Rear Speed Sensor LH - Vehicle Stability Control System (for Hydraulic Brake Booster)

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster): C1235/35,C1236/36,C1238/38,C1239/39: Foreign Object is Attached on Tip of Front Speed Sensor RH
C1239/39 - Foreign Object is Attached on Tip of Rear Speed Sensor LH

DESCRIPTION

The Skid Control ECU sets this DTC if, according to abnormal signals input by the sensor, it detects that foreign material is adhering to the speed sensor tip or the sensor rotor, or the rotor has any missing teeth.

This DTC may be set if parts such as the speed sensor circuit connector or wire harness are malfunctioning.





HINT
DTC C1235/35 relates to the front speed sensor RH.

DTC C1236/36 relates to the front speed sensor LH.

DTC C1238/38 relates to the rear speed sensor RH.

DTC C1239/39 relates to the rear speed sensor LH.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - SPEED SENSOR) C0200

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. INSPECT MASTER CYLINDER SOLENOID (TERMINAL VOLTAGE)

(a) Disconnect the speed sensor connectors.





(b) Turn the ignition switch to the ON position.

(c) Measure the voltage.

Standard Voltage:





(d) Turn the ignition switch to OFF.

(e) Reconnect the speed sensor connectors.

NG -- REPLACE MASTER CYLINDER SOLENOID
OK -- Continue to next step.

3. RECONFIRM DTC

(a) Clear the DTCs Vehicle Stability Control System (for Hydraulic Brake Booster).

(b) Check if the same DTCs are recorded.





B -- CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
A -- Continue to next step.

4. INSPECT SPEED SENSOR

(a) Remove the speed sensor Removal or Removal).

(b) Check the sensor tip.

OK:

No scratches or foreign matter on the sensor tip.

NG -- CLEAN OR REPLACE SPEED SENSOR

OK -- CLEAN OR REPLACE SPEED SENSOR