Installation

PARKING BRAKE: PARKING BRAKE PEDAL: INSTALLATION

1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

(a) Install the control pedal to the body with the 3 nuts.





Torque : 13 Nm (127 kgf-cm, 9 ft-lbf)

(b) Attach the wire harness clamp to the control pedal.





(c) Connect the parking brake switch connector.

2. CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY

(a) Connect the parking brake cable to the control pedal.





(b) Using needle-nose pliers, slowly bend down the claw.

NOTICE:
Be careful not to damage the parking brake cable or claw.

(c) Install the clip to the control pedal.





(d) Temporarily install the adjustment nut and lock nut.





HINT
The nuts will be tightened to a torque specification in the "ADJUST PARKING BRAKE PEDAL TRAVEL" procedure.

3. CHECK PARKING BRAKE PEDAL TRAVEL Adjustments

4. ADJUST PARKING BRAKE PEDAL TRAVEL Adjustments

5. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY Installation

6. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH Installation

7. INSTALL INSTRUMENT SIDE PANEL LH Installation

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL