Installation

2TR-FE ENGINE CONTROL: AIR FUEL RATIO SENSOR: INSTALLATION

1. INSTALL AIR FUEL RATIO SENSOR

(a) Using SST, install the air fuel ratio sensor.





SST : 09224-00010

without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)

with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

Text in Illustration





HINT
* Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Service Precautions.
* Make sure SST and the wrench are connected in a straight line.

(b) Attach the wire harness clamp.

(c) Connect the air fuel ratio sensor connector.

2. INSPECT FOR EXHAUST GAS LEAK Installation

3. INSTALL FRONT NO. 1 FENDER APRON TO FRAME SEAL RH Installation