Removal

2GR-FE ENGINE CONTROL SYSTEM: KNOCK SENSOR: REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE Removal

2. REMOVE ENGINE UNDER COVER LH

3. REMOVE ENGINE UNDER COVER RH

4. DRAIN ENGINE COOLANT Testing and Inspection

5. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH Removal

6. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH Removal

7. REMOVE FRONT FENDER TO COWL SIDE SEAL LH Removal

8. REMOVE FRONT FENDER TO COWL SIDE SEAL RH Removal

9. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal

10. REMOVE WINDSHIELD WIPER MOTOR AND LINK Removal

11. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY Removal

12. REMOVE COOL AIR INTAKE DUCT SEAL Removal

13. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

14. REMOVE AIR CLEANER INLET ASSEMBLY Removal

15. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal

16. REMOVE AIR CLEANER CASE SUB-ASSEMBLY Removal

17. REMOVE NO. 1 AIR CLEANER INLET Removal

18. REMOVE INTAKE AIR SURGE TANK Removal

19. SEPARATE FUEL TUBE SUB-ASSEMBLY Removal

20. REMOVE INTAKE MANIFOLD Removal

21. REMOVE KNOCK CONTROL SENSOR

(a) Disconnect the 2 knock control sensor connectors.





(b) Remove the 2 bolts and 2 knock control sensors.