Skid Control Buzzer Circuit

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: Skid Control Buzzer Circuit
- Skid Control Buzzer Circuit

DESCRIPTION

The skid control buzzer sounds while the VSC is activated.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform the zero point calibration Calibration.

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM

(a) Check if a CAN communication system DTC is output How to Proceed With Troubleshooting.

Result:





B -- REPAIR CAN COMMUNICATION SYSTEM CAN Communication System
A -- Continue to next step.

2. PERFORM ACTIVE TEST USING TECHSTREAM (BUZZER)

(a) Connect the Techstream to the DLC3.

(b) Start the engine.

(c) Select the Active Test mode on the Techstream Data List / Active Test.

ABS/VSC/TRAC:





OK:

The skid control buzzer can be heard.

OK -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal
NG -- Continue to next step.

3. INSPECT COMBINATION METER ASSEMBLY

(a) Inspect the combination meter How To Proceed With Troubleshooting.

NG -- REPLACE COMBINATION METER ASSEMBLY Removal

OK -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal