Slip Indicator Light Remains ON

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: Slip Indicator Light Remains ON
- Slip Indicator Light Remains ON

DESCRIPTION

The slip indicator blinks during VSC and/or TRAC operation.

When the VSC/TRAC system fails, the slip indicator comes on to warn the driver.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform the zero point calibration Calibration.

PROCEDURE

1. PREPARE FOR INSPECTION

(a) Check that the following condition is satisfied.

The vehicle is not in inspection mode.

HINT
Confirm if the vehicle is in the inspection mode or not by using the Techstream Data List.

NEXT -- Continue to next step.

2. CHECK CAN COMMUNICATION SYSTEM

(a) Check if a CAN communication system DTC is output How to Proceed With Troubleshooting.

Result:





B -- REPAIR CAN COMMUNICATION SYSTEM CAN Communication System
A -- Continue to next step.

3. CHECK SKID CONTROL ECU CONNECTOR

(a) Check if the skid control ECU connector is securely connected.

OK:

The connector is securely connected.

NG -- CONNECT CONNECTOR CORRECTLY
OK -- Continue to next step.

4. INSPECT COMBINATION METER ASSEMBLY

(a) Inspect the combination meter How To Proceed With Troubleshooting.

NG -- REPLACE COMBINATION METER ASSEMBLY Removal

OK -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal