Radiator Cooling Fan Motor Relay: Testing and Inspection

2GR-FE COOLING: COOLING FAN RELAY: ON-VEHICLE INSPECTION

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE ENGINE ROOM NO. 2 RELAY BLOCK COVER

3. INSPECT NO. 1 FAN RELAY (Marking: FAN NO. 1)





(a) Remove the relay from the engine room No. 2 relay block.

(b) Measure the resistance of the relay.

Standard resistance:





If the result is not as specified, replace the relay.

(c) Install the relay.

4. INSPECT NO. 2 FAN RELAY (Marking: FAN NO. 2)





(a) Remove the relay from the engine room No. 2 relay block.

(b) Measure the resistance of the relay.

Standard resistance:





If the result is not as specified, replace the relay.

(c) Install the relay.

5. INSTALL ENGINE ROOM NO. 2 RELAY BLOCK COVER

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL