Rear Axle Hub

AXLE: REAR AXLE HUB: ON-VEHICLE INSPECTION

1. REMOVE REAR WHEEL

2. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY

(a) Remove the rear disc brake cylinder assembly Removal.

3. REMOVE REAR DISC Disassembly

4. CHECK BEARING BACKLASH AND AXLE HUB DEVIATION

(a) Using a dial indicator, measure the backlash near the center of the axle hub.





Maximum backlash:

0.05 mm (0.00197 in.)

If the backlash is greater than the maximum, replace the axle hub.

(b) Using a dial indicator, measure the deviation on the surface of the axle hub outside the hub bolt.

Maximum deviation:

for 2WD
0.08 mm (0.00315 in.)

for 4WD
0.06 mm (0.00236 in.)

If the deviation is greater than the maximum, replace the axle hub.

5. INSTALL REAR DISC Reassembly

6. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY

(a) Install the rear disc brake cylinder assembly Installation.

7. INSTALL REAR WHEEL