Installation

STEERING COLUMN: STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column): INSTALLATION

1. INSTALL STEERING COLUMN ASSEMBLY





(a) Install the steering column with the bolt and 2 nuts.

Torque : 21 Nm (214 kgf-cm, 16 ft-lbf)

(b) Connect the connectors and wire harness clamps.

2. INSTALL NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY





(a) Align the matchmarks on the No. 2 steering intermediate shaft and power steering gear.

(b) Install the bolt.

Torque : 35 Nm (357 kgf-cm, 26 ft-lbf)

3. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY





(a) Align the matchmarks on the steering intermediate shaft and No. 2 steering intermediate shaft.

(b) Install the bolt.

Torque : 35 Nm (357 kgf-cm, 26 ft-lbf)





(c) Align the matchmarks on the steering column and steering intermediate shaft.

(d) Install the bolt.

Torque : 35 Nm (357 kgf-cm, 26 ft-lbf)





(e) Install the 3 bolts and nut.

Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)

4. INSTALL NO. 3 AIR DUCT SUB-ASSEMBLY





(a) Install the air duct with the bolt.

5. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY Installation

6. INSTALL INSTRUMENT SIDE PANEL LH Installation

7. INSTALL COWL SIDE TRIM BOARD LH Installation

8. INSTALL FRONT DOOR SCUFF PLATE LH Installation

9. INSTALL COMBINATION SWITCH WITH SPIRAL CABLE Installation

10. INSTALL TILT AND TELESCOPIC MANUAL SWITCH





(a) Attach the claw to install the tilt and telescopic switch.

(b) Connect the connector.

11. INSTALL UPPER STEERING COLUMN COVER Installation

12. INSTALL LOWER STEERING COLUMN COVER Installation

13. ADJUST SPIRAL CABLE Installation

14. INSTALL STEERING WHEEL ASSEMBLY Installation

15. INSPECT STEERING WHEEL CENTER POINT

16. INSTALL STEERING PAD Installation

17. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation

18. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation

19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

20. INSPECT SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.

21. CUSTOMIZE INFORMATION

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Utility / Customize Setting / Tilt & Telesco.

(e) Turn the auto away/return function ON.