Installation

AXLE AND DIFFERENTIAL: REAR AXLE HUB: INSTALLATION

HINT
* Use the same procedure for the LH side and RH side.
* The procedure listed below is for the LH side.

1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY LH

(a) Apply MP grease to a new O-ring.

(b) Install the new O-ring to the rear axle hub and bearing.





NOTICE:
Do not damage the O-ring.

(c) Install the axle hub and bearing to the rear axle carrier with the 4 bolts.





Torque : 86 Nm (877 kgf-cm, 64 ft-lbf)

2. INSTALL REAR AXLE ASSEMBLY

(a) Install the rear upper control arm with the bolt and nut.





(b) Align the matchmarks on the No. 1 rear suspension arm and adjust cam.

(c) Install the No. 1 rear suspension arm with the bolt and nut.

* Bolt A

Torque : 250 Nm (2549 kgf-cm, 185 ft-lbf)

* Bolt B

Torque : 185 Nm (1886 kgf-cm, 137 ft-lbf)

3. INSTALL NO. 2 REAR SUSPENSION ARM ASSEMBLY LH

(a) Install the No. 2 rear suspension arm to the rear axle with the nut.

Torque : 130 Nm (1326 kgf-cm, 96 ft-lbf)





(b) Install a new cotter pin.

4. INSTALL REAR AXLE SHAFT NUT LH

(a) Using a 39 mm socket wrench, install the rear axle shaft nut LH.

Torque : 340 Nm (3467 kgf-cm, 251 ft-lbf)





(b) Install the adjusting lock cap and new cotter pin.

5. INSTALL REAR HUB GREASE CAP LH

(a) Install the rear hub grease cap LH.

NOTICE:
Mark sure to securely fit the bearing to the axle hub.

6. INSTALL REAR SPEED SENSOR LH

(a) Using a hexagon wrench, install the rear speed sensor with the bolt.





Torque : 8.3 Nm (85 kgf-cm, 73 in-lbf)

NOTICE:
* Make sure that there are no pieces of iron or other foreign matter attached to the sensor tip part.
* While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip part.
* After installing the speed sensor, make sure that there is no clearance or foreign matter between the sensor stay part and the knuckle.
* Make sure that there is no foreign matter attached to the magnetic rotor.

(b) Connect the rear speed sensor connector.

7. INSTALL PARKING BRAKE ASSEMBLY

Reassembly

8. INSTALL REAR PNEUMATIC CYLINDER ASSEMBLY LH (for Pneumatic Cylinder Type)

Installation

9. INSTALL REAR COIL SPRING LH (for Coil Spring Type)

Installation

10. INSPECT REAR WHEEL ALIGNMENT (for Pneumatic Cylinder Type)

Rear Wheel Alignment