Pinout Values and Diagnostic Parameters

1NZ-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: TERMINALS OF ECM





HINT
The standard normal voltage between each pair of ECM terminals is shown in the table below. The appropriate conditions for checking each pair of terminals are also indicated. The result of checks should be compared with the standard normal voltage for that pair of terminals, displayed in the Specified Condition column. The illustration above can be used as a reference to identify the ECM terminal locations.













HINT
*: The ECM terminal voltage is constant regardless of the output voltage from the sensor.

1. WAVEFORM 1





Camshaft timing oil control valve (OCV)





2. WAVEFORM 2





Air-fuel ratio sensor heater





HINT
The wavelength varies in accordance with the engine operating condition.

3. WAVEFORM 3





Heated oxygen sensor





HINT
In DATA LIST, item O2S B1S2 shows the ECM input values from the heated oxygen sensor.

4. WAVEFORM 4





Fuel injector No. 1 (to No. 4) injection signal





HINT
The wavelength becomes shorter as the engine rpm increases.

5. WAVEFORM 5





Knock sensor





HINT
* The waveforms and amplitudes displayed differ slightly depending on the vehicle.

6. WAVEFORM 6





Crankshaft position sensor and Camshaft position sensor





HINT
The wavelength becomes shorter as the engine rpm increases.

7. WAVEFORM 7





Igniter IGT signal (from ECM to igniter) and Igniter IGF signal (from igniter to ECM)





HINT
The wavelength becomes shorter as the engine rpm increases.

8. WAVEFORM 8





Purge VSV





HINT
If the waveform is not similar to the illustration, check the waveform again after idling for 10 minutes or more.

9. WAVEFORM 9





Vehicle speed signal





HINT
The wavelength becomes shorter as the vehicle speed increases.

10. WAVEFORM 10





Throttle actuator positive terminal





HINT
The duty ratio varies depending on the throttle actuator operation.

11. WAVEFORM 11





Throttle actuator negative terminal





HINT
The duty ratio varies depending on the throttle actuator operation.

12. WAVEFORM 12





Engine speed signal





HINT
The wavelength becomes shorter as the engine rpm increases.

13. WAVEFORM 13





Reference: CAN communication signal





HINT
The waveform varies depending on the CAN communication signal.

14. WAVEFORM 14





Reference: CAN communication signal





HINT
The waveform varies depending on the CAN communication signal.