Operation CHARM: Car repair manuals for everyone.

Removal





DOOR LOCK: FRONT DOOR LOCK: REMOVAL

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure is for the LH side.

1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG Disassembly

4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH Disassembly

5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) Disassembly

6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) Disassembly

7. REMOVE FRONT ARMREST ASSEMBLY Disassembly

8. REMOVE COURTESY LIGHT ASSEMBLY Removal

9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

10. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP Disassembly

11. REMOVE DOOR SIDE AIRBAG SENSOR Removal

12. REMOVE FRONT DOOR SERVICE HOLE COVER Disassembly

13. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY Disassembly

14. REMOVE FRONT DOOR GLASS RUN Disassembly

15. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY Disassembly

16. REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (w/ Lock Cylinder) Disassembly

17. REMOVE FRONT DOOR LOCK WITH MOTOR ASSEMBLY

(a) Using a T30 "TORX" socket wrench, remove the 3 screws.





Text in Illustration





(b) Slide the front door lock with motor assembly downward, and remove the front door lock with motor assembly and cables as a unit.

(c) When reusing the front door lock with motor assembly.

(1) Remove the door lock wiring harness seal from the front door lock with motor assembly.





18. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY Disassembly

19. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY Disassembly