Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: STEERING ANGLE SENSOR: INSTALLATION

NOTICE:
A lock pin is installed to a new steering sensor. Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.

1. INSPECT SPIRAL CABLE SUB-ASSEMBLY Installation

2. INSTALL STEERING SENSOR

(a) Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.





Text in Illustration





NOTICE:
* Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.
* Do not damage the pins of the spiral cable sub-assembly and guides of the steering sensor.
* The spiral cable sub-assembly can be rotate up to 30° even when the interlock is engaged. Therefore, make sure that both guides are aligned properly when installing the steering sensor to the spiral cable sub-assembly.

(b) Remove the lock pin from the steering sensor.





3. ALIGN FRONT WHEELS TO FACE STRAIGHT AHEAD

4. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Installation