Removal

POWER DISTRIBUTION: INTEGRATION RELAY: REMOVAL

1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE NO. 1 RELAY BLOCK COVER

(a) Disengage the 2 claws and remove the No. 1 relay block cover as shown in the illustration.





4. REMOVE ENGINE ROOM JUNCTION BLOCK ASSEMBLY

(a) Disengage the 2 claws as shown in the illustration.





Text in Illustration





(b) Using pliers, pull up the engine room junction block assembly at the position indicated in the illustration and disconnect the 4 connectors from the engine room relay block assembly.

NOTICE:
When pulling a engine room junction block assembly, take care not to damage the engine room junction block assembly.

HINT
Tape the pliers tip before use.

(c) Disconnect the 2 connectors and remove the engine room junction block assembly.





NOTICE:
* Do not drop or allow any impact on parts.
* Do not touch the connector.