Installation

2AR-FE ENGINE CONTROL: ECM: INSTALLATION

1. INSTALL NO. 1 ECM BRACKET

(a) Install the No. 1 ECM bracket with the nut.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(b) Connect the wire harness clamp.

(d) Install the nut.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

2. INSTALL ECM

(a) Install the No. 2 ECM bracket to the ECM with the 2 screws.

Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

(b) Temporarily install the screw (B).

(c) Install the ECM with the nut.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(d) Install the screw (A).

Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

(e) Tighten the screw (B).

Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

(f) Connect the 2 ECM connectors and lower the 2 levers.

NOTICE:
* When connecting the connectors, make sure that dirt, water or other foreign matter does not become stuck between the connectors and other part.
* Make sure that the 2 levers are securely locked.

(g) Connect the 2 wire harness clamps.

3. INSTALL BATTERY Installation

4. INSTALL COOL AIR INTAKE DUCT SEAL Installation

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

6. PERFORM INITIALIZATION

Service Precautions