Removal

2AR-FE ENGINE CONTROL: ECM: REMOVAL

NOTICE:
Perform the Vehicle Identification Number (VIN) registration when replacing the ECM Programming and Relearning.

HINT
When removing only the ECM, it is not necessary to remove the cool air intake duct seal and battery.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE BATTERY Removal

4. REMOVE ECM

(a) Disconnect the 2 ECM connectors.





(1) Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.

NOTICE:
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.

(b) Remove the nut.





(c) Remove the screw (A).

(d) Loosen the screw (B) and remove the ECM.

(e) Remove the screw (B).

(f) Remove the 2 screws and No. 2 ECM bracket.





5. REMOVE NO. 1 ECM BRACKET

(a) Remove the nut.





(b) Disconnect the wire harness clamp.

(c) Disconnect the wire harness clamp.





(d) Remove the nut and No. 1 ECM bracket.