Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR (for Front Side): REMOVAL

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing.

for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor

for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG Disassembly

4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH Disassembly

5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) Disassembly

6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) Disassembly

7. REMOVE FRONT DOOR ARMREST ASSEMBLY Disassembly

8. REMOVE COURTESY LIGHT ASSEMBLY Removal

9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

10. REMOVE DOOR SIDE AIRBAG SENSOR

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Disconnect the connector from the door side airbag sensor.

NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.

(1) Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)





Text in Illustration





(2) Push down the white housing lock again and disconnect the connector.

NOTICE:
Do not push down the part (A) shown in the illustration when disconnecting.

(d) Remove the bolt and door side airbag sensor from the front door panel.





NOTICE:
Loosen the bolt while holding the door side airbag sensor because the door side airbag sensor pin (stopper) is easily damaged.

(e) After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.





Text in Illustration