Front Door Disassembly

1. Using a molding remover, disengage the 3 claws and remove the front door inside handle bezel plug.





2. Disengage the 3 clips and remove the front door lower frame bracket garnish.

3. For LH front door.





Remove power window regulator master switch assembly with front door armrest base panel.

A. Using a molding remover, disengage the 2 clips, 5 claws and 4 guides.

B. Disconnect each connector and remove the power window regulator master switch assembly with front door armrest base panel.

4. For RH front door.





Remove power window regulator switch assembly with front door armrest base panel.

A. Using a molding remover, disengage the 2 clips, 5 claws and 4 guides.

B. Disconnect each connector and remove the power window regulator switch assembly with front door armrest base panel.





5. Using a molding remover, disengage the 3 clips, 7 claws and 2 guides and remove the front armrest assembly.

6. Remove courtesy light assembly.





A. Using a pry tool, disengage the claw.

B. Disconnect the connector and remove the courtesy light assembly.
7. Remove front door trim board sub-assembly.





A. Put protective tape around the front door panel.

B. Remove the 3 screws.





C. Using a clip remover, disengage the 10 clips.





D. Pull out the front door trim board sub-assembly in the direction indicated by the arrow.

E. Disengage the reference boss from the front door panel.

NOTE
Reference boss must be disengaged fully from the door panel, before raising or damage will occur.

F. Raise the front door trim board sub-assembly to remove the front door trim board sub-assembly together with the front door inner glass weatherstrip.





G. Disconnect the front door lock remote control cable assembly and front door inside locking cable assembly.





8. Using a screwdriver or pry tool, disengage the 4 claws and remove the front door inner glass weatherstrip from the front door trim board sub-assembly.