Rear Door Disassembly

1. Using a molding remover, disengage the 3 claws and remove the rear door inside handle bezel plug.





2. Remove rear power window regulator switch assembly with rear door armrest base panel.

A. Using a molding remover, disengage the 2 clips, 5 claws and 4 guides.

B. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.





3. Using a molding remover, disengage the 3 clips, 7 claws and 2 guides and remove the rear armrest assembly.





4. Remove rear door trim board sub-assembly.

A. Put protective tape around the rear door panel.

B. Remove the 3 screws.





C. Using a clip remover, disengage the 8 clips.

D. Pull out the rear door trim board sub-assembly in the direction indicated by the arrow as shown in Figure 20.





E. Disengage the reference boss from the rear door panel.

F. Raise the rear door trim board sub-assembly to remove the rear door trim board sub-assembly together with the rear door inner glass weatherstrip.





G. Disconnect the rear door lock remote control cable assembly and rear door inside locking cable assembly.





H. Using a screwdriver or pry tool, disengage the claw and remove the No. 1 door scuff plate clamp from the rear door trim board sub-assembly 2.

5. Using a screwdriver or pry tool, disengage the 3 claws and remove the rear door inner glass weatherstrip from the rear door trim board sub-assembly.