Installation

U660E AUTOMATIC TRANSMISSION / TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Move the shift lever to N.

(b) Align the protrusions of the park/neutral position switch.





Text in Illustration





(c) Install the park/neutral position switch to the control shaft with the 2 bolts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

NOTICE:
* Before installing the park/neutral position switch, remove any dirt or rust on the installation portion of the control shaft. Be sure to install the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch cannot be reinstalled correctly.
* After installing the park/neutral position switch, confirm that the 2 protrusions on the switch are aligned.

(d) Install the control shaft lever to the control shaft with the nut and washer.

Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)

(e) Connect the connector to the park/neutral position switch.

2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Connect the transmission control cable assembly to the transmission control cable bracket with a new clip.

(b) Connect the transmission control cable assembly to the control shaft lever with the nut.

Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)

NOTICE:
Before connecting the transmission control cable assembly, check that the park/neutral position switch and the shift lever are in neutral.

3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation

4. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation

6. INSTALL INLET NO. 2 AIR CLEANER Installation

7. INSTALL COOL AIR INTAKE DUCT SEAL Installation

8. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION Component Tests and General Diagnostics

9. INSPECT SHIFT LEVER POSITION Adjustments

10. ADJUST SHIFT LEVER POSITION Adjustments