Installation

EXTERIOR: REAR BUMPER: INSTALLATION

1. INSTALL REAR BUMPER BAR BRACKET LH

(a) Insert the hook into the body hole and install the rear bumper bar bracket with the bolt.





Torque : 8.0 Nm (80 kgf-cm, 71 in-lbf)

2. INSTALL REAR BUMPER BAR BRACKET RH

HINT
Use the same procedure as for the LH side.

3. INSTALL REAR BUMPER SIDE SUPPORT SUB-ASSEMBLY LH

(a) Align the locating pin with the hole and install the rear bumper side support with the 2 bolts.





Torque : 8.0 Nm (80 kgf-cm, 71 in-lbf)

4. INSTALL REAR BUMPER SIDE SUPPORT SUB-ASSEMBLY RH

HINT
Use the same procedure as for the LH side.

5. INSTALL REAR BUMPER SIDE STAY LH

(a) Insert the hook into the body hole and install the rear bumper side stay with the bolt.





Torque : 8.0 Nm (80 kgf-cm, 71 in-lbf)

6. INSTALL REAR BUMPER SIDE STAY RH

HINT
Use the same procedure as for the LH side.

7. INSTALL REAR BUMPER ENERGY ABSORBER

(a) Engage the 2 claws and install the rear bumper energy absorber.

8. INSTALL REAR BUMPER UPPER RETAINER LH

(a) Engage the 3 claws and install the rear bumper upper retainer.

(b) Tighten the 2 screws.

Torque : 3.0 Nm (30 kgf-cm, 27 in-lbf)

9. INSTALL REAR BUMPER UPPER RETAINER RH

HINT
Use the same procedure as for the LH side.

10. INSTALL REAR BUMPER END RETAINER LH

(a) Engage the 2 claws and install the rear bumper end retainer.

(b) Tighten the screw.

Torque : 3.0 Nm (30 kgf-cm, 27 in-lbf)

11. INSTALL REAR BUMPER END RETAINER RH

HINT
Use the same procedure as for the LH side.

12. INSTALL REAR BUMPER COVER

(a) Engage the 6 claws and the 2 clips and install the rear bumper cover.

(b) Connect the connector.

(c) Connect the clamp and install the floor wire.

HINT
If the vehicle is equipped with back sonar, connect the connector and install the floor wire.

(d) Tighten the 7 bolts and the 2 screws.

Torque : 8.0 Nm (80 kgf-cm, 71 in-lbf) for bolt

Torque : 3.0 Nm (30 kgf-cm, 27 in-lbf) for screw