Removal

U151E AUTOMATIC TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE BATTERY Removal

3. REMOVE COOL AIR INTAKE DUCT SEAL Removal

4. REMOVE NO. 2 AIR CLEANER INLET Removal

5. REMOVE NO. 1 AIR CLEANER INLET Removal

6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal

7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY Removal

9. REMOVE AIR CLEANER BRACKET Removal

10. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Remove the nut from the control shaft lever.





(b) Disconnect the control cable from the control shaft lever.

(c) Remove the clip and disconnect the control cable from the control cable bracket.

NOTICE:
Do not hold the resin guide pipe.





11. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Disconnect the park/neutral position switch connector.





(b) Remove the nut, washer and control shaft lever.





(c) Using a screwdriver, pry up the lock plate.





(d) Remove the lock nut and lock plate.





(e) Remove the 2 bolts and pull out the park/neutral position switch.