Disassembly

LIGHTING (EXT): REAR COMBINATION LIGHT ASSEMBLY: DISASSEMBLY

1. REMOVE REAR COMBINATION LIGHT BODY GASKET

(a) Remove the 2 rear combination light body gaskets.





NOTICE:
* Be sure to remove all the traces of the old gaskets from the body.
* Do not reuse the removed gaskets. Be sure to install new rear combination light body gaskets to prevent water ingress.

2. REMOVE REAR COMBINATION LIGHT GASKET

(a) Remove the rear combination light gasket.





NOTICE:
* Be sure to remove all the traces of the old gasket from the body.
* Do not reuse the removed gasket. Be sure to install a new rear combination light gasket to prevent water ingress.

3. REMOVE REAR TURN SIGNAL LIGHT BULB

(a) Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration, and disconnect them as a unit.





(b) Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.

4. REMOVE BACK-UP LIGHT BULB

(a) Turn the rear combination light socket and wire sub-assembly with the back-up light bulb in the direction indicated by the arrow shown in the illustration, and disconnect them as a unit.





(b) Remove the back-up light bulb from the rear combination light socket and wire sub-assembly.

5. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY

(a) Disconnect the connector.





(b) Disengage the claw and remove the rear combination light socket and wire sub-assembly.