Section 1: Diagnostic Procedure

1. Place vehicle in "IG-ON" mode. Wait about 15 seconds.

NOTE

Do NOT press brake pedal. Press Power switch twice.

2. Press the SOS button located on the overhead map light assembly. Then within 10 seconds, press the SOS button a second time (to cancel SOS call placement).

NOTE

The Safety Connect system when functioning with a valid account will facilitate audio communication with an emergency call center agent. The purpose of pressing the SOS button a second time is to terminate the call so that an emergency is not presumed by the Safety Connect call center.

3. Is there an audio prompt heard?

^ YES - Continue to step 4.

^ NO - STOP. This bulletin does NOT apply. If Safety Connect account is valid, then diagnose for inoperative Safety Connect function per the Repair Manual.

4. Was the audio prompt loud and clear?

^ YES - STOP This bulletin does NOT apply.

^ NO - Proceed to the Wire Harness Repair Procedure in this bulletin.

5. Switch the vehicle to IG-OFF mode.